Record Details

Effect of vibration on forced convection to water from a cylinder at Reynolds numbers in the range of stable vortex shedding

ScholarsArchive at Oregon State University

Field Value
Title Effect of vibration on forced convection to water from a cylinder at Reynolds numbers in the range of stable vortex shedding
Names Graves, Donald Larry (creator)
Wilson, Robert E. (advisor)
Date Issued 1964-07-16 (iso8601)
Note Graduation date: 1965
Abstract An experimental investigation has been made of the effect of
vibration on heat transfer from a cylinder in crossflow. The
cylinder used was 3/16-inch in diameter and was sinusoidally
oscillated in the vertical direction by a mechanical drive mechanism
while immersed in an open water channel. Nominal amplitude
ratios, a/d, varied from 0.125 to 1.43 while frequency varied from
0 to 6.5 cycles per second. Data was taken at three flow Reynolds
numbers: 64; 103 and 144. Temperature difference between the
cylinder and the water was held at approximately 10°F. A hydrogen
bubble technique was used in conjunction with dye studies to observe
the flow near the cylinder.
It was found that the heat transfer could be increased or decreased by vibration, depending on the amplitude ratio and the
vibrational Reynolds number, (N[subscript Re])[subscript v] = awρ d/√2μ. Below a critical
vibrational Reynolds number, which increased with the flow Reynolds
number, oscillation had no effect on the heat transfer. After this
critical point was passed, the data for the amplitude ratios 0.125,
0.250, and 0.500 showed a decrease in the heat transfer while the
data for higher amplitude ratios (a/d = 1.00; 1.43) gave a steady increase.
After reaching a minimum, the data for a/d = 0.500 increased
to converge with the data of higher amplitudes; this trend was also
suggested by the lower amplitude ratios but was not completely substantiated
because of the frequency limitation of the drive mechanism.
The maximum decrease in the heat transfer below stationary conditions
was about 20 percent; the maximum increase in the heat transfer
was 180, 125, and 90 percent for flow Reynolds numbers of 64;
103 and 144 respectively.
The vortex shedding frequencies were in the range of frequency
used for mechanical oscillation; noting this, an attempt was made to
oscillate the cylinder through the immediate frequency range of
vortex shedding to see if any special heat transfer effects would
result. No change occurred other than the general increase due to
increasing the vibrational intensity.
The increases in heat transfer are attributed to vibrationally
induced turbulence. An adequate explanation of the decreases in heat transfer was not provided by this investigation; however, it is
thought that the phenomenon occurring may be similar to the observations
of Kubanskii (11) who imposed acoustical vibrations on a
cylinder in crossflow. By appropriately locating the cylinder with
respect to the nodes of the sound field he found that the point of flow
separation shifted toward the upstream side of the cylinder resulting
in lower heat transfer rates.
A critical (N[subscript Re])[subscript v]/(N[subscript Re])[subscript f] required to alter the heat transfer
was established for this investigation and although it had a weak
dependence on the amplitude ratio, a value of 0.35 serves as a good
approximation for the data of this experiment.
Genre Thesis/Dissertation
Topic Heat -- Convection
Identifier http://hdl.handle.net/1957/48626

© Western Waters Digital Library - GWLA member projects - Designed by the J. Willard Marriott Library - Hosted by Oregon State University Libraries and Press