Record Details
Momentum transfer in climbing-film flow in an annular duct
ScholarsArchive at Oregon State University
| Field | Value |
|---|---|
| Title | Momentum transfer in climbing-film flow in an annular duct |
| Names |
Kim, Duk Hwang
(creator) Knudsen, James G. (advisor) |
| Date Issued | 1965-04-02 (iso8601) |
| Note | Graduation date: 1965 |
| Abstract | Momentum transfer in an annular duct with upward gas-Iiquid flow was studied under the condition that the liquid flowed as a film only on the inner core of the annulus, the outer wall remaining dry. Previous workers have studied climbing and falling liquid films in tubes or on vertical planes. With this type of apparatus it is very difficult to study pressure losses, gas velocity profiles, and the structure of the climbing film. The difficulty has been overcome by forming a liquid film on the inner core and maintaining a dry outer wall of an annular duct. The column consists of a three-inch I.D. outer tube with a concentric one-inch O.D. inner core. The inner tube was supported laterally by sets of streamlined centering screws. The total length of the column was about 35 feet and the test section was 20 feet long. All measurements were made at two stations, the first was 76 inches from the liquid injector, the second 154 inches from the liquid injector. The liquid injector is a porous stainless steel cylinder with one inch O.D. and two inch length. The air flow rates varied from 170 cfm to 410 cfm at 1 atmosphere pressure and 68° F temperature. The water flow rates used were 0.47 lbm/min and 0.79 lbm/min. The study has two major divisions. First division is the study of the mechanics of the air flow in the annulus as it is affected by the presence of the climbing film of liquid. This portion of the study involves an investigation of velocity profiles, the point of maximum velocity, friction losses, and the role of capillary waves in the annular flow. It was found that: 1) the pressure loss for climbing film flow in an annulus can be predicted by the Lockhart and Martinelli correlation for two-phase flow in tubes, 2) the capillary waves of the climbing film affect only the location of the point of maximum air velocity and the air velocity profile at the inner portion of the annulue, 3) the location of the point of maximum air velocity shuts to the outer wall as water film is introduced, 4) the air velocity profiles in the inner portion of the annulus with the film present, plotted as u⁺ versus y⁺, are shifted downward, relative to those for annular flow without the film, although they have same slope. The second part is the study of the mechanics of flow of a climbing water film which has a solid wall as one boundary and highly turbulent air stream as the other. The mean film thickness, wave length, and amplitude of the climbing film were measured by a photographic method. This method gave good results in the measurement of mean film thickness at the lower and moderate air velocities. However, the wave length and amplitude determined by this method have only a qualitative significance, because of the irregularity of wave shapes. With increasing air flow rates, the film thickness, wave length, and amplitude decreased. Generally the ratio of wave length to amplitude varied between 20 to 30. As a first approximation, Kapitza's theory of wave formation in the vertical plane with downward flow, based on laminar conditions, was extended to the climbing film in an annular duct in order to obtain an expression for the mean film thickness, the velocity profile of liquid film, and the wave length. Comparison between the prediction and the experiment was found to be reasonably good, The mean film thickness data for climbing film flow in an annulus was correlated with the Lockhart and Martinelli parameters, R[subscript L] and X, and was compared with the correlation for climbing film flow in a tube. If a unique correlation for climbing film flow in both tubes and annuli exists (this is the original proposal of Lockhart and Martinelli), it would appear that the region in the vicinity of x = 0.01 is a transition region. More data at high water flow rates are necessary to reach a general conclusion concerning the correlation. |
| Genre | Thesis/Dissertation |
| Topic | Fluid dynamics |
| Identifier | http://hdl.handle.net/1957/48080 |
